Yealink Factory Reset

Yealink Factory Reset

This is only recommended after you have tried all other troubleshooting suggestions since the operation will delete all your personal configuration settings and reset them to the factory defaults. It is therefore advisable to have your phone system administrator backup your personalized settings before proceeding with a factory reset.

To  perform factory reset of the phone via the phone user interface:

  • When the phone is idle you can long press the OK key.
    • For T57W, or Touchscreen phones with no OK button, long press the   (redial key) until “Reset to factory setting?” window appears.
  • The phone prompts you to reset the setting or not.
  •  Select OK  to confirm.
  • The screen prompts “Welcome Initializing…Please wait”.



    The phone will be reset to factory successfully after startup.

    The process may take a few minutes. Do not power off until the phone starts up successfully.

Factory Resetting the W60B Base

The following steps may also apply to Yealink models W52B, W70B and W80B.

From The Base

  1. Power off the unit by unplugging the power cord from the back (for PoE, disconnect the network cable).
  2. Wait for 15 seconds.
  3. With the unit unplugged, press and hold the connect button on the base station.
    w60b base connect button
  4. While still holding the connect button, plug the power (or network cable if PoE) back into the unit.
  5. Wait until all three lights on the unit are showing as solid green, and release the connect button.
  6. Wait approximately 5 minutes.
  7. Reboot the unit by unplugging it from power for 15 seconds and plugging it back in.

From a Connected Handset

  1. Press the OK button in the middle of the phone to bring up the Phone’s menu.
    ok button
  2. Using the directional buttons, navigate to Settings and press OK.
    settings
  3. Enter System Settings by pressing 8 on the dialpad, or scrolling down (with directional buttons) and pressing OK.
    system settings
  4. Navigate to Base Reset and press OK.
    base reset
  5. Enter the PIN for your device (default is “0000”) and press Done.
    enter pin
  6. The base will now factory reset and upon completion, will display “Success” (or similar) on the phone screen.
    success
  7. Once done, pair the handset by following this guide https://emak.tech/support/how-to-setup-a-yealink-cordless-phone/

    • Related Articles

    • Yealink Phone User Guides

      Yealink Phone User Guides This is an article containing all the info needed to use your Yealink desk phone. Using Your Phone Feature Guide Checking Voicemail How to Access Voicemail Call Transfer Yealink Call Transfer Call Forward How to Use Call ...

    • Connect Yealink Phone via WiFi

      If your phone comes with built in WiFi follow the steps below: Go to Menu > Basic > Wi-Fi Or to Menu > Settings > Basic Settings > Wi-Fi (depends on the phone model) Choose Available Network[s] Choose Enter Choose the desired Wi-Fi network Choose ...

    • How to Assemble a Yealink Phone

      Attach the stand Connect the handset Connect the network and power Attach the stand Follow the steps in the diagram below Plug in Handset Next, plug the short side of the handset cable into the handset and the longer side into the handset port on the ...

    • How to setup a Yealink Cordless Phone

      Step 1 – Hardware Power Up Plug the Base Station into the power Power ON the Handset Plug the Handset charging cradle. Step 2 – Handset Registration to the Base Long press the button on top of the base station till the registration LED slow flashes. ...

    • Voicemail Setup

      One of the first steps you should perform after receiving your phones is personalizing your voicemail greeting. This is the message that plays when you miss a call before the caller leaves a message. If you do not set up your greeting, the default ...